Solid Inspector 2 will fix many issues, but you will need to fix some yourself manually.A Manifold Solid at least as far as SketchUp is concerned has the following properties:- It is a Container i.e.
If you Select it and the Entity Info top-bar says Solid then it is a Solid BUT subject to the provisos at the end. Geometry is defined as Edges and Faces CurvesArcsCircles are made from Edges, Surfaces are made from Faces. Although the non-interacting Guide-lines and Guide-points are also allowed and probably would not affect an export to STL or similar, Id still recommend you avoid including them. So the exclusion list includes nested Groups or Component-instances, Text, Dims etc. You example does contain some nested parts in the microphone There are further limitations on its Geometry. This means that an Edge CANNOT: be faceless have only one face - e.g. There are CleanUp plugins to remove coplanar or stray-edges etc. You can use Xray mode and temporary Section-cuts to access the inside of these forms to tidy them up by Deleting unwanted edgesfaces. Front-faces Style-dependent, but usually off-white to the outside, and back-faces Style-dependent, but usually blue-gray to the inside. Once you have a Solid, then the Context-menu Orient will fix this. To treble-check for this, you can take a Container and edit it, Select All and Context-menu Intersect with Context. If you exit the Edit and its still a Solid in Entity Info all is OK. If it is not then something was wrongs and you need to fix it, as outlined earlier.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |